With the rapid development of my country’s industry and high-pressure washer technology, the requirements for the quality of industrial cleaning are getting higher and higher. Especially for some heavy industrial occasions, such as petroleum, chemical plants, power plants and other equipment and occasions with a lot of industrial oil pollution, it is extremely important to ensure the cleaning effect and efficiency. The use and maintenance of a high-pressure washer are inseparable. The service life of the high-pressure washer is closely related to how we use it. As long as the high-pressure washer is turned on and used, we must pay attention to maintenance. The maintenance of high-pressure washer is divided into daily maintenance and regular maintenance. Although daily maintenance has few steps, the effect is absolutely good.
Next, I will introduce to you the daily maintenance and regular maintenance of the high-pressure washer.
Daily maintenance:
1. Check the lubricating oil in the high-pressure pump crankcase every day. It is recommended to replace the lubricating oil every three months.
2. Clean the water inlet filter once every two weeks.
3. Clean the fuel nozzle and ignition electrode once a month
4. Replace the fuel filter once every three months.
5. Disassemble and clean the high-pressure pump once every three months.
Regular maintenance:
1. Regularly clean the precipitated impurities in the oil tank of the high-pressure washer, and add enough oil in time to ensure healthy engine operation and extend the engine’s operating life.
2. When the high-pressure washer is completed, it should be covered with a protective cover in time to prevent the high-pressure washer from being corroded, prematurely worn and dusted, causing certain parts to be blocked. Also, the valves and sealing rings should be coated with lubricant to prevent them from being damaged. Stuck next time I use it.
In addition to the daily maintenance and upkeep of the high-pressure washer , we must also learn to troubleshoot some minor problems that usually occur.
Below, we will analyze with you the causes and treatment methods of insufficient water pressure of the high-pressure washer :
1. The high-pressure nozzle of the high-pressure washer is seriously worn. Excessive wear of the high-pressure nozzle will affect the water outlet pressure of the equipment. New nozzles should be replaced in time.
2. Insufficient water flow rate connected to the equipment results in insufficient water flow rate, resulting in insufficient output pressure. Sufficient inlet water flow should be supplied in time to solve the problem of reduced outlet water pressure.
3. If there is air in the clean water inlet filter of the high-pressure washer, the air in the clean water inlet filter should be exhausted to ensure that the standard water outlet pressure is output.
4. After the overflow valve of the high-pressure washer ages, the water overflow volume will be large and the pressure will become low. When the overflow valve is found to be aging, the accessories must be replaced in time.
5. The high and low pressure water seals and water inlet and outlet check valves of the high-pressure cleaning machine leak, resulting in low working pressure. These accessories should be replaced in time.
6. The high-pressure pipes and filtering devices are kinked, bent or damaged, resulting in poor water flow and insufficient outlet water pressure. They should be repaired in time.
7. There is an internal failure of the high-pressure pump, the wearing parts are worn, and the water flow rate is reduced; the internal pipelines of the equipment are clogged, and the water flow rate is too small, resulting in too low working pressure.
About us, Taizhou Shiwo Electric & Machinery Co,. Ltd is a big enterprise with industry and trade integration, which is specializing in manufacturing and exporting of various kinds of welding machines, air compressor, high pressure washers, foam machines, cleaning machines and the spare parts. The headquarter is located at Taizhou city, Zhejiang province, South of China. With modern factories covering an area of 10,000 square meters, with more than 200 experienced workers. Besides, we have more than 15 years of experience in supplying chain management of OEM & ODM products. Rich experience helps us to constantly develop new products to meet the ever-changing market needs and customer requirement. All of our products are greatly appreciated in Southeast Asia, European, and South American markets.
Post time: Jul-26-2024